Connecting The Equipment - Omron POWLI BU60RE Instruction Manual

2-3

Connecting the equipment

Do not connect devices with rated voltage of 100 to 120 VAC or higher.
The rated output voltage of this device is 100 to 120 VAC.
Overcurrent may damage the connected devices.
2-3-1. Connecting a device to the power supply output
(1) Connect devices (computer, server, peripherals, etc.) that require backup to the power supply out-
put receptacle on the back of the unit.
Make sure that the total capacity of devices connected to the output receptacle
does not exceed the output capacity rating of this unit. If the overload indicator (
appears, reduce the number of connected devices.
• When using a 2-pin input plug, you may directly connect to a Power Supply Output Receptacle
of the UPS. Note 1) When using a 2-pin input plug with a grounding wire, connect the ground-
ing wire to earth in building.
• When you want to use an AC adaptor, connect it to the earth terminal of the UPS with space
enough for the connection.
Connect it directly.
(Note 1) This connection is prohibited to use the UPS as device complying with UL Standards or
CE Marking.
(2) When using the included UPS monitoring software and the Windows standard UPS service, use
a connection cable to connect the unit to the PC.
See also "7. Using the UPS monitoring software and Contact Signal" on page 43.
* If you do not use the UPS monitoring software and Contact Signal, this step is not required.
Caution
Connect it directly.
Plug of connected
device
Connect the grounding wire of connect
devices to earth of the UPS. (Note 1)
Computer
To power supply
output receptacle
Connect the plug directly.
Plug of connected
device
Connect the grounding wire to
the earth terminal of the UPS.
60 100
BU RE/BU RE
)
Plug of connected
device
2
13