Omron POWLI BU60RE Instruction Manual page 28

2
.Installation and connection
(5) In Battery Mode, check the unit's LED display and beep sound.
Does the status indicator appear as one of those shown below?
Status indicator
If not the same as one of those shown above: → Operation is abnormal. Check the status of lamps and beep
Setting switch
See also
(6) Reconnect the AC input plug to the commercial power source.
The status indicator returns to its normal state and the beeping sound stops.
(The status is as shown below.)
Status indicator
Checking the operation is now complete.
Installation and connection is now complete.
16
Beep Output Charging
Intermittent
4-second ON
Discharging
intervals
Intermittent
1-second ON
Discharging
intervals
None OFF
Discharging
can be used to turn the beeper ON/OFF. → Page 28
Description
Power switch "ON"
Operating normally
OFF Backup is operating due to power failure or AC input er-
ror. Output will stop if Battery Mode continues.
OFF (Same as above.)
Battery level is low, so output will stop soon.
OFF Battery is dead, so output stopped. (This is displayed
only for a few seconds.)
and turn OFF the "Power" Switch.
• If the display is one of those shown in "4. Displays and
beeps when there is an equipment failure" in "3-3 Inter-
preting beeps and displays" on page 23, take the neces-
sary measures and then go back to (1) on page 15.
• If no Battery Mode is performed and the UPS and the
devices connected to the UPS stop, this may be attrib-
uted to an insuffi cient battery charge.
After connecting the AC input plug to a wall outlet (com-
mercial power) and charging the battery, go back to step
(4) on page 15.
• If the problem persists after checking the 2 points above,
contact us; ____
( indicates blinking)
Description