Omron POWLI BU60RE Instruction Manual page 18

2
.Installation and connection
Do not use the unit where the maximum temperature exceeds 55°C.
The battery becomes weak rapidly, which may cause a fi re.
Doing so may cause a failure or malfunction of the unit.
Do not exceed the ranges specifi ed for environmental conditions during
use/storage.
Do not install or store the unit in the places listed below.
Do not store in places where the humidity is lower than 10% or higher than 90%.
Do not use the unit in places where the ambient temperature is lower than -10°C or higher than
55°C. (With no condensation)
Do not use in places where the humidity is lower than 10% or higher than 90%.
Do not install/store the unit in closed places such as cabinets with no clearance, places where
there is flammable or corrosive gas, places with large amounts of dust, places exposed to
direct sunlight, places exposed to shock or vibration, or outdoors.
Installation or storing the unit in such a place may cause a fi re.
Do not connect equipment that exceeds the output capacity of the unit.
You can use a plug strip to connect additional devices, but do not connect
devices that exceed the current capacity of the plug strip.
The current protection of the unit may operate, which may stop the output.
The wiring of the plug strip heats up, which may cause a fi re.
Do not pinch or sharply bend the cable.
Do not fold or knot the cable.
Doing so may cause the cable to be damaged or heated, which may cause
an electric shock or a fi re.
If the cable is damaged, stop using the unit and have the cable repaired.
For repair, contact us; ____
The accessories are designed exclusively for use with this unit.
Do not use any of the included accessories with other devices.
Doing so may compromise the safety of devices.
Do not block the air vents (front and rear).
Doing so will cause the internal temperature to rise, which may cause the unit to fail and the bat-
tery to deteriorate.
Leave at least 5 cm of space between the vent and the wall.
Do not connect devices that cannot be used with commercial power
supply.
When the ECO Mode is set and an error occurs with the connected device, bypass operation is
performed and commercial power supply is supplied as is to the connected devices.
When installing the unit on a rack, place it on the lower shelf.
Injury may result if the unit falls.
Make sure to use the mounting screws included with the brackets.
Mounting screws other than those included may not be strong enough to support the unit, caus-
ing it to fall.
If you attach the case using long screws other than those included with the product, you may
damage the internal parts of the unit.
6
Caution
(for installation and connection)