Omron POWLI BU60RE Instruction Manual page 21

2-2-1. Rackmount installation (EIA /JIS 19-inch rack/server rack)
When performing rack installation, ensure that the UPS is supported and
stabilized by using both the support angles and the table clamps that
were included.
When connecting an additional battery unit, be sure to place the battery
unit in a position lower than the main unit.
When installing on a rack, make sure that the UPS is supported by the each unit individually.
When installing on a rack, make sure to use the support angles and table clamps included with
the product. Without the support angles, the front clamp alone cannot support the weight of the
UPS.
The mass of each unit: BU60RE: Approx. 15.5 kg
In a case where the UPS is to be mounted on a rack, place it on the lower
part of the rack.
Dropping it may result in injury.
Be sure to use the supplied mounting screws.
Use of long screws other than those supplied for case mounting may damage inside the unit.
Screws other than those supplied may not be strong enough to support the UPS, causing it to fall.
Items included in the 19-inch rack support angle mounting bracket set
Rack rail (front) L ................................................... 1
Rack rail (front) R ................................................... 1
Rack rail (rear) ........................................... ............ 2
Ear brackets .............................................. ............ 2
Rail length fixing screws (M4) ................ ................ 4
Ear bracket mounting flat-head screws (M3).... ...... 8
EIA/JIS rack fixing screws (M5) ........................... 10
JIS rack fixing flat-head screws (M5) ...................... 2
EIA rack fixing nuts (M5) ................................ ...... 10
Rack mounting procedure
(1) Insert the 4 included rail length fi xing screws (M4) and half-tighten them to hold the front and
rear rack rails in place.
Caution
BUM100RE: Approx. 25 kg
4 rail length fixing screws (small)
60
BU RE/BU
BU100RE: Approx. 18.5 kg
100
RE
2
9