Yamaha CE50T Service Manual page 90

_i CYLINDER AND CYLINDER HEAD
_; 1. Install:
®Cylinder gasket (New gasket)
2. Offset the piston ring end gaps as shown.
(_ 1st ring
_) 2nd ring
NOTE:
oBe sure to check the manufacturer's marks or
numbers stamped on the rings are on the top
side of the rings.
oBefore installing the cylinder, apply a liberal
coating of 2-stroke to the pisotn rings.
3. Install:
• Reed valve
oCarburetor joint (_
B°'t (Carburet°r J°int): I
8 Nm (0.8 m okg, 5.8 ft.lb)
;_i_;_ J 4. Install:
• Cylinder (_
;_ NOTE:
Install the cylinder with one hand while compress-
ing the piston rings with the other hand.
5. Pass the oil delivery pipe as shown,
3-45