INFO
iMPORTANT
iNFORMATiON
BEARINGS AND OIL SEALS
i. Install the bearing(s) and oil seal(s) with their
manufacturer's marks or numbers facing out-
ward. (In other words, the stamped letters
__)
_
must be on the side exposed to view.) When
installing oil seal(s), apply a light coating of
light-weight lithium base grease to the seal
lip(s). Oil the bearings liberally when installing.
(_ Oil seal
Do not use compressed
air to spin the bear-
(_
ings dry. This causes damage to the bearing
surfaces.
(_ Bearing
CIRCLIPS
1. All circlips should be inspected carefully
e ore
reas e r eo
ace
O ton
clips after one use. Replace distorted circlips.
_/._/7_/_////_
When installing a cirelip (_, make sure th at
the sharp edged corner (_ is positioned op-
posite to the thrust (_) it receives. See the
/J
sectional view.
(_)
(_) Shaft
1-3