Yamaha CE50T Service Manual page 181

sq s,ooAL S,STEM I 1
4. "'OIL" indicator light does not work
No
Checkfor voltage (12V) on "Br" lead at oil level voltage I Wiring circuitfrom fuse to oil level
gauge connector. __1 gauge connector is faulty, repair.
'_ No
|
Check fOrconnector.VOltage (12V) on "Gy" lead at oil level ____1, Check for condition of oil level
-- i gauge. If oil level gauge is poor
gauge
I condition, replace it.
_,_OK No
Check for voltage (12V)on "B" lead at "OIL" I v°Itage_ __i IndicatOr light bulb socket is faul-
indicator light connector, ty, replace it.
[Oil level gauge check]
1. Disconnect:
eOil level gauge leads
2. Remove:
®Oil level gauge
3. Connect:
• Pocket Tester (YU-03112)
Set the tester selector to "9 x 1" position.
/_ ....i_;;, 4. Check:
• Oil level gauge conduct
Refer to following table
_ Not per result--* Replace.
Float position Good
: Up (_ No continuity
Down (_ Continuity
5. Taillight does not work
Check for voltage (12V) on "Br" lead at taillight No voltage _ I Wiring circuit from fuse to taillight
connector, r _ connector is faulty, repair.
L
I Taillight bulb socket is faulty, replace it. 1
|
6-44