Yamaha CE50T Service Manual page 222

ENGINE OIL LEVEL INSPECTION
ADJ
_
NOTE:
If the main switch is turned off after the "OIL"
light goes off and then immediately again the main
switch is turned on, the "OIL" light may not come
on. This is not because of failure.
(~ "OIL" indicator light
Always use the same type of engine oil; mix-
ing oils may result in a harmful chemical
reaction and lead to poor performance.
AUTOLUBE PUMP AIR BLEEDING
The oil pump and delivery line must be bled
on the f o l l o w i n g occasions:
=Any portion of the oil system has been dis-
connected.
=The scooter has been turned on its side.
=Whenever the oil tank has been run empty.
e During predelivery.
1. Remove:
oTail cover
Refer to "TAIL COVERS AND MOLES"
section.
ePump cover ( ~
2. Fill:
®Oil tank
Recommended Oil:
Yamalube " 2 " or Air-cooled 2
Stroke Engine Oil
3. Place a rag or oil pan under the oil pump to
catch oil.
4. Remove:
o Bleed screw ( ~
5. Inspect:
®Gasket (Bleed screw)
Damage-* Replace.
--9--