Yamaha CE50T Service Manual page 59

O,SASSEMOL [ENOL
_zi;ili_:_ _- CRANKCASE AND CRANKSHAFT
1. Remove:
: : eOil seal stopper (_)
®Circlip (_)
"'_ 2. Remove:
oScrews (Crankcase)
NOTE:
Loosen each screw 1/4 turn, and remove them
after all are loosened.
_, 3. Attach:
oCrankcase Separating Tool (YU-01135) (_
_ NOTE:
Fully tighten the-tool holding bolts, but make sure
the tool body is parallel with the case. If
necessary, one screw may be backed out slight-
ly to level tool body.
_ _i __:i: _: . ....
_:?. _
4. Remove:
eCrankcase (Left)
As pressure is applied, alternately tap on the
engine mounting bosses.
"::"- i ": "" !: i. :: • "
Use soft hammer to tap on the case half. Tap
only on reinforced portions of case. Do not
tap on gasket mating surface. Work slowly
and carefully. Make sure the case halves
separate evenly. If one end "hangs up", take
3-14