Yamaha CE50T Service Manual page 232

S ONA. S STEM [ELEC ]
2. "OIL" indicator light does not work
NO
VOLTAGE
Check for voltage (12V) on "Br" lead at "OIL" _ Wiring circuit from fuse to "OIL" indi-
indicator light connector. _ cator light connector is faulty, repair.
JvL OK NO
Check for voltage (12V) on "Gy" lead at "OIL .... OIk" indicator light socket is faulty,
indicator light connector. _ replace it.
-J_,LOK NO
VOLTAGE
Check for voltage (12V) on "Gy" lead at oil ___ Wiring circuit from "OIL" indicator
level gauge connector. ----------F light to oil level gauge is faulty, repair.
Check for condition of oil level gauge. Refer
to "OIL LEVEL GAUGE CHECK".
Oil Level Gauge Check
1. Remove:
oOil level gauge (_)
NOTE:
Do not disconnect the oil level gauge lead.
2. Turn the main switch to "ON".
3. Check
oOil level gauge
Refer to follOwing table.
Not per result-* Replace.
Oil level gauge "OIL" indicator light
position
®Light comes on
Upright position eWait a few second
®Light goes out
oLight comes on
Up-side down eWait a few second
position ®Light stays on
--19--