Yamaha CE50T Service Manual page 131

FRONT FORK AND STEERING
[CHASI ® ]
6. Tighten:
®Ring nut (_
Using the Ring Nut Wrench _ (YU-33975).
[_ Ring Nut @: 1
30 Nm (3.0 m,kg, 22 ft.ib)
NOTE:
Set the torque wrench to the Ring Nut Wrench
so that they form a right angle (_.
7. Check:
oSteering column for smooth action
!i_i!_i_:_i_:. Slack_Tighten the ring nut.
_:i.:_-_,:\_,_: Sticky--* Loosen the ring nut.
8. Install:
oHandlebar (_
oBolt (_ (New)
®Nut (_ (New)
NOTE:
Fit the handlebar bridge @ into the steering
column notcher (_.
! ,Before installing the handlebar, wipe the oil
.......... off the insertion portion (_) using thinner,
etc.
..... olnstall the bolt (_ from the right as shown.
®Make sure that the slit (_ has enough
clearance after tightening the nut _).
i
Always use a new bolt (_ and nut _),
*/_ I_ B°ltlHandlebar) @: I
60 Nm (6.0 m,kg, 43 ft.lb)
9. Install:
FWD ,,Inner fender with cable guide
L
5-18