Faculty Test; Faculty Tests; Sensor Tests - Canon MF8100 Series Service Manual

Memo
The transmission level for each baud rate and speed follows the service data.

5.5.4.5 Faculty Test

5.5.4.5.1 FACULTY Tests

The faculty tests are selected by pressing the numeric key 6 from the test mode menu.
These tests test the following faculties of this fax.
Test type

Sensor tests

Operation panel test
Line signal reception test
5.5.4.5.2 Sensor Tests
The sensor test is selected by pressing the numeric key 3 from the faculty test menu. In this test, you can check the status of each sensor of this fax in items 1 to 4
on the display.
You can also check if sensors that use actuators and microswitches are operating correctly by moving the actuator or microswitch.
Cursor key
Overview
Test whether the sensors are operating correctly.
Tests whether the button switches on the control panel are operating
correctly.
Tests whether the NCU board signal sensor and frequency counter are
operating correctly.
6-3 SENSOR
[1 ] - - - [ 4 ]
Pressing the 1 key
CRG of FCV on
ALS [ON of of of of]
CRG : Cartridge sensor on/of
FCV : Front cover switch on/of
ALS : Cassette recording paper sensor/Manual paper feed sensor
/Top sensor/Paper delivery sensor/Paper full sensor on/of
Pressing the 2 key
JAM of JAM 000
TN of TN253
JAM : Paper delivery jam detection on/of
TN : Toner sensor on/of and toner amount
JAM000 : JAM code display
010:Pickup delay jam
020:Pickup stationary jam
030:Delivery delay jam
040:Delivery stationary jam
050:Wrap jam/Initial jam
060:Cover open jam
Pressing the 3 key
DS of DES of HPS of
DS : Document sensor on/of
DES : Document edge sensor on/of
HPS : Home position sensor on/of
Pressing the 4 key
0000000000
Not used
Speed
7.2 kbps
4.8 kbps
2.4 kbps
T-5-11
F-5-13
Chapter 5
0008-1992
0008-1993
5-11