Points To Note When Mounting The Adf Unit; Scanner Cover Unit; Removing The Rear Cover; Removing The Scanner Unit - Canon MF8100 Series Service Manual

[1]
4) Open the ADF unit [1] as shown; then, disengage it starting with the rear
and then the front.
[1]
[A]

3.3.2.5 Points to Note When Mounting the ADF Unit

Be sure to observe the following when mounting the ADF unit:
If the harness [1] is too taut, a break in the line can occur. Be sure there is
some slack when the ADF unit [2] is fully open.

3.3.3 Scanner Cover Unit

3.3.3.1 Removing the Rear Cover

1) Disconnect the cable [1] of the power supply assembly.
2) Open the face-up cover [2], and remove the 4 screws [3] of the rear cover.
[2]
F-3-338
[D]
[C]
[A]
[B]
[B] [C]
F-3-339
[2]
[1]
F-3-340
[3]
3) Open the reader assembly [4], and lift to free the 2 claws [5].
4) Close the reader assembly; then, detach the rear cover[1].
0009-8277
[3]
F-3-343

3.3.3.2 Removing the Scanner Unit

1) Remove the platen glass cover.
2) While removing the left and right claws, detach the hinge cover [1].
3) Remove the screw [2], and detach the cable guide [3].
0007-8075
4) Open the harness band [1], and free the 2 cables [2] connected to the
reader assembly.
[1]
[2]
F-3-341
[5]
F-3-342
[1]
[3]
[2]
[1]
[3]
[2]
F-3-344
Chapter 3
[3]
[4]
0007-8076
3-53