[2]
[1]
Be sure to tighten the self-tapping screw used to secure the rotary drive as-
sembly only at the end of the work.
3.5.3.14 Removing the Left Frame
1) Remove the 4 screws [1], and detach the left frame [2].
[1]
3.5.3.15 Removing the Fan Duct
1) Disconnect the 4 connectors [1], and remove the 2 claws [2].
2) Slide the fan duct [3] in upward direction to detach.
[1]
[1]
[1]
[1]
3.5.3.16 Removing the Laser Scanner Unit Base
1) Disconnect the 6 connectors [1] of the DC controller board.
[2]
[3]
[2]
F-3-585
[2]
[1]
F-3-586
[3]
[2]
F-3-587
2) Free the harness [1] from the harness guide [2].
3) Disconnect the connector [3], and remove the 8 screws [4]; then, detach
the laser scanner base [5]
0007-8810
[3]
0007-8847
3.5.3.17 Removing the Developing Rotary Assembly
1) Remove the 2 screws [1].
2) Push in the top [2] of the rotary holder toward the inside of the machine
using the tip of a screwdriver to see that the holder has been disengaged
from the machine.
0007-8849
[2]
[1]
F-3-588
[4]
[4]
[5]
[4]
F-3-589
[1]
F-3-590
Chapter 3
[2]
[1]
0007-8850
3-89