Removing The Fixing Film Unit - Canon MF8100 Series Service Manual

Chapter 3
[1] [3]

3.7.2.3 Removing the Fixing Film Unit

1) Unhook the 1 claw [1] and remove the pressure roller gear[2].
2) Unhook the 1 claw [3] and remove the delivery roller gear[4].
3) Remove the idle gear[5].
4) Pressing the boss [1] inward, rotate the delivery idle gear shaft holder [2]
in the direction of the arrow and remove the holder together with the
delivery idle gear shaft [3].
5) Remove the 4 screws [1]; then, remove the 2 claws [2] and the boss [3] to
detach the fixing upper cover [4].
3-156
[2]
[1]
F-3-1010
[1]
[2]
[5]
[4] [3]
F-3-1011
[1]
[2]
[3]
F-3-1012
[1]
0011-7554
[4]
Make sure that the 2 springs are fitted onto the bosses on the fixing upper
cover when reassembling the cover. See the figure for the correct positions
of the boss and springs (shown on the left).
6) Remove the upper separation guide [1].
7) Remove the 2 releasing levers [2].
8) Slide the pressure plate [4] in upward direction, and remove the 2 bosses
[3].
9) Remove the pressure plate [4] from the fixing assembly.
[4]
[3]
10) Disconnect the connector [1], and free the cable [2] from the clamp [3].
11) Remove the screw [4].
[2]
[1]
[3]
F-3-1013
[1]
[2]
F-3-1014
[2]
[1]
[2]
[4]
[3]
F-3-1015