[1]
Enlarged View of the Paper Retainer
OK
[3]
When attaching the top cover, be sure to fit the link lever [2] while keeping
the drive release lever [1] in up position (i.e., with drive disengaged).
If you are fitting the drum cartridge in the machine with the top cover re-
moved, be sure to do so with the drive release lever [1] fully in up position
(i.e., with drive disengaged).
If the drive release lever is in low position (i.e., with drive engaged), it forces
out the coupling [2], causing the coupling to interface with the drum car-
tridge and to suffer damage.
[2]
F-3-610
NG
[3]
F-3-611
[2]
[1]
F-3-612
3.5.4.8 Removing the Left Frame
1) Remove the 4 screws [1], and detach the left frame [2].
[1]
3.5.4.9 Removing the Shift Motor
1) Disconnect the connector [1], and remove the 2 screws [2].
2) Slide the shift motor [3] in upward direction to detach.
[2]
[1]
[3]
[2]
3.5.5 Developing Rotary Motor
3.5.5.1 Removing the Rear Cover
1) Disconnect the cable [1] of the power supply assembly.
2) Open the face-up cover [2], and remove the 4 screws [3] of the rear cover.
Chapter 3
[1]
[2]
F-3-613
[2]
[1]
F-3-614
F-3-615
0007-8811
0007-8880
0007-8557
3-93