Removing The Dust-Blocking Cover; Removing The Inside Cover; Removing The Density Detection Pcb - Canon MF8100 Series Service Manual

[1]
Enlarged View of the Paper Retainer
OK
[3]
When attaching the top cover, be sure to fit the link lever [2] while keeping
the drive release lever [1] in up position (i.e., with drive disengaged).
If you are fitting the drum cartridge in the machine with the top cover re-
moved, be sure to do so with the drive release lever [1] fully in up position
(i.e., with drive disengaged).
If the drive release lever is in low position (i.e., with drive engaged), it forces
out the coupling [2], causing the coupling to interface with the drum car-
tridge and to suffer damage.
[2]
F-3-685
NG
[3]
F-3-686
[2] [1]
F-3-687

3.5.7.8 Removing the Inside Cover

1) Remove the 2 claws [1], and detach the inside cover [2].
[2]

3.5.7.9 Removing the Dust-Blocking Cover

1) Remove the claw [1], and detach the dust-blocking cover [2].
[1]

3.5.7.10 Removing the Density Detection PCB

1) Remove the 2 screws [1], and disconnect the connector [2]; then, detach
the density detection PCB [3].
Chapter 3
[1]
[2]
F-3-688
[1]
F-3-689
[2]
F-3-690
0007-8856
0007-8858
0007-8859
3-105