Removing The Modular Pcb; Removing The Modular Board Cover; Power Supply Pcb; Removing The Rear Cover - Canon MF8100 Series Service Manual

[2]
5) Remove the 2 screws [1] from the back; then, shift the scanner unit [2] to
the back, and lift it to detach.
[1]

3.2.14.3 Removing the Modular Board Cover

1) Remove the 2 screws [1], and detach the modular board cover [2].
[2]
[1]
Pay attention to the harness [3].

3.2.14.4 Removing the Modular PCB

1) Disconnect the cable [1], and remove the 2 screws [2]; then, detach the
modular board [3].
[3]

3.2.15 Power Supply PCB

3.2.15.1 Removing the Rear Cover

1) Disconnect the cable [1] of the power supply assembly.
2) Open the face-up cover [2], and remove the 4 screws [3] of the rear cover.
[2]
[1]
F-3-170
[2]
F-3-171
[3]
F-3-172
[2]
[1]
F-3-173
[3]
3) Open the reader assembly [4], and lift to free the 2 claws [5].
0007-8069
4) Close the reader assembly; then, detach the rear cover[1].
[3]
F-3-176

3.2.15.2 Removing the Reader Assembly

1) Open the reader assembly, and remove the left and right E-rings [1]; then,
0007-9111
pull out the pin [2].
0007-7019
[1]
[3]
[2]
F-3-174
[4]
[5]
F-3-175
[1]
[3]
[2]
[1]
[1]
[2]
[2]
F-3-177
Chapter 3
0007-8458
3-27