Configure The Meridian Sl-100 For The Kba - Avaya 3900 Series User Manual

Installation
Install a Single KBA Footstand
1. Insert the clips on both the telephone and the Key-based Expansion Module into
2. While squeezing the telephone and KBA tilt handles, swing the footstand into the
3. Turn the new assembly upright.
Install an Expansion KBA Footstand Assembly
1. Place the Single KBA Footstand Assembly and the Expansion KBA Footstand
2. Align the Expansion KBA Footstand Assembly with the Single KBA Footstand
3. Insert two screws through the Expansion KBA Plate into the Single KBA Footstand
Figure 18: Expansion KBA Footstand
4. Tighten all four screws, ensuring that the two footstand assemblies are properly
5. Insert the clips on the telephone and the Key-based Expansion Modules into the
6. Turn the completed assembly upright.

Configure the Meridian SL-100 for the KBA

Table 20: SERVORD configuration for the KBA
SERVORD commands you use to configure the Meridian SL-100 for the KBA.
Each Key-based Expansion Module provides 22 additional Line/Feature Keys. Configure these
additional keys in SERVORD. Key numbers associated with the first Key-based Expansion
90 Avaya 3900 Series Digital Deskphones User Guide
the hinges on the footstand assembly and press on the front of the footstand until
they snap into place.
desired position.
Assembly face down on a flat surface.
Assembly and slide them together.
Assembly (see Figure 18: Expansion KBA Footstand
aligned.
hinges on the combined Single/Expansion KBA Footstand Assembly, and while
squeezing the Module Tilt Handles, swing the footstand into the desired position.
on page 90).
on page 91 shows an example of the
August 2010