SECTION 4—SEAT
SECTION 4—SEAT
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that ON/OFF
switch on the joystick is in the OFF position.
Removing/Installing or Tilting the Seat Assembly
Removing/Installing the Seat Assembly without Powered Seating
Systems
NOTE: For this procedure, refer to FIGURE 4.1.
Removing
1. Disconnect the joystick. Refer to Disconnecting/Connecting the Joystick on page 92.
2. M91 with Full Recline Back and Drive Lockout Switch ONLY - Perform the following
to disconnect the drive lock out switch:
A. Open rear shroud by turning knob 90° until detent is felt, slide rear shroud towards
rear casters and tilt top edge away from wheelchair.
B. Disconnect the drive lockout switch cable located next to the charger (Detail "A" of
FIGURE 4.1).
C. Close the rear shroud by tilting the top edge towards the wheelchair, sliding the
rear shroud towards the knob, and turning knob 90° until detent is felt.
3. Push down on the latch bar underneath front of seat.
4. Tilt front edge of seat up.
5. Slide the seat assembly forward to disengage seat from the pivot brackets located in
the rear.
Installing
1. Position the seat in the rear pivot brackets as shown in FIGURE 4.1.
2. Tilt front edge of seat down.
3. When seat is lowered, engage seat brackets into seat clevis pins.
When reinstalling the seat verify that the seat brackets are engaged with the seat
clevis pins by pulling up on the latch bar.
®
™
Pronto
M91 and M94
WARNING
WARNING
30
Part No. 1125038