Northern Telecom 3X8 Owner's Handbook Manual page 77

72 Using features
code
Invalid
Dialing and answering the telephone
Many features require you to dial telephone numbers.
The displays associated with dialing are listed in the Dialing
section. If you see a display that is not listed with the feature you
are using, look for it in the Dialing section. All the displays that
appear when you are receiving a call are listed in the Answering
the telephone section.
One button access
You can program most
memory buttons so that you can use the feature by pressing a
single button. See the procedures in the Feature programming
section.
Whenever the instructions tell you to enter a featuie code, you
can do so either by pressing the buttons shown in the feature
description or by pressing a memory button on which the feature
code has been programmed. You can also enter a telephone
number by pressing an
manually.
Canceling a feature
Some features change the way your telephone works. To make
your telephone work normally again you must cancel the feature.
To cancel a feature, press (Feature], then
code. For example, to cancel Call Forward, which you activate by
pressing [Feature]
DR5.1 Owner's Handbook
You have entered an invalid feature
You have tried to use a feature that is
not available in the present set-up of
your system.
You cannot use the feature you have
chosen because your telephone is
locked. See Telephone Administration
Lock in Customizing your telephone.
feature codes onto telephone
button, rather than entering it
q
and the feature
press
PO842627 01