PDT 8000 Series Product Reference Guide
Sending the Hex Image
Once the hex file is built, you are ready to download it to the terminal. A Hex image
download requires both TCM and a program loader stored on the terminal. The terminal
comes with a program loading utility, Initial Program Loader (IPL), stored in the terminal's
write-protected flash. To run IPL, the terminal must be connected to a development PC by
direct serial connection.
Connect the Terminal and Development PC
To send the hex file to the terminal, first connect the terminal and development PC by one
of the following devices:
•
Serial Charging Cable (p/n 25-55853-01)
•
Single-Slot Serial Cradle (p/n CRD8000-1000S).
Set Up IPL to Receive the File
Note: IPL only recognizes files in the 8.3 format (file names can have up
to eight characters, followed by a period and an extension of up to
three characters). It does not support long file names.
64MB RAM Configuration
To set up IPL on the terminal to receive the files being downloaded via TCM:
Note: Terminal display is in landscape mode in IPL. Therefore, rotate your
terminal 90 degrees to the right to read the display correctly.
1. Hard reset the terminal by removing the battery door and pressing the Power key
and a Scan button, simultaneously.
2. Press the 5 key when three } appear on the bottom left of the screen.
12-12