PDT 8000 Series Product Reference Guide
5. A schannel.dll dialog box may appear. Disregard the message and tap OK. Wait
for installation to complete.
6. After installation is complete, a Spectrum24 Install dialog box appears. Tap OK.
7. Hard reset your terminal. See
Configuration
The purpose of the patch is to provide the capability to use LEAP by installing necessary
software and firmware. The configuration of the Spectrum 24 radio card using LEAP must
be done through a registry file in the Platform folder, since NICTT does not allow for this
configuration. During the installation of the patch, NICTT is removed from the terminal.
To copy the file from your terminal
1. Establish an ActiveSync connection between the host computer and the terminal.
Depending on the accessory used for the connection, see the appropriate section
in
Chapter 4,
9-18
Performing a Hard Reset
Communications.
on page 2-35.