Sending The Hex Image Using Ipl - Symbol MC909X Integrator Manual

Select the items (partitions) to build using the check box(es) to the left of each named partition.
2.
The
3. Build Path
Select (hex image) COMPRESSION to reduce the size and speed up the download.
4.
Click and follow the on-screen instructions.
5. OK
If one of the partitions being built is the ESSID, a prompt appears requesting the ESSID value. Deselect
the HR (High Rate) check box when building ESSID images for a device with an FH radio.
Build ESSID Partition Window
Figure 7-8
If one of the partitions being built is the Splash Screen, a prompt appears requesting both the source
Bitmap file and the destination HEX file.
A check is performed and if there are no errors, the partition hex files are created.
6.
If the build fails, the hex files are not be created and TCM displays an error message. Two of the most common
reasons for a build failure are:
Files defined in the script can not be found. This error can occur when the files referenced by the script
•
are no longer stored on the development computer or the folders where they are stored were renamed.
The total amount of flash memory space required by the script exceeds the image size. To correct this,
•
reduce the number of files in the partition or increase the size of the partition. See
Properties on page 7-8

Sending the Hex Image Using IPL

Once the hex file is built, it can be downloaded to the mobile computer using IPL.
NOTE If you are using an SD/MMC memory card to load a hex image onto the mobile computer, you must first
copy the files to the SD/MMC card and install the card into the memory slot under the keyboard. See
Media Card (MMC) / Secure Device (SD) Card on page 2-4
card.
Press the battery eject button to release the battery but do not remove completely.
1.
Press and hold the trigger and the Power button while re-inserting the battery until the mobile computer
2.
resets into IPL.
Release the power button while holding down the trigger.
3.
Insert the mobile computer into cradle or connect CAM while continuing to hold the trigger.
4.
defines where to store all built partitions.
for more information about setting the image size appropriately.
Application Deployment for WinCE 5.0 7 - 11
for instructions for installing an SD/MMC
Defining Script
Multi