Ericsson iPECS LIP-8002E User Manual page 250

LIP-8040E Gigabit Phone
To place a call using Dial by Name:
•
•
•
•
To enter your station user name:
•
•
•
1. Select ABC> or abc> mode by pressing 2
2. To input 1
•
Press DIR Soft button,
Dial the desired directory, 1: Private directory, 2: Public
directory, 3: Intercom directory, the LCD will display the names
in alphabetical order,
Scroll using the Navigation up/down keys, or enter search
characters (refer to the above Character Entry Chart).
Press /
HOLD SAVE
Press the /
TRANS
Dial 74(iPECS-LIK)/34(iPECS SBG-1000)/12(iPECS-MG)
(Station User Name code),
Enter the Name, up to 12 characters (press DND button to
backspace/delete a character):
- To input alphabet
Button,
st
character in each dial button(2~9), press
the button, once,
nd
To input 2 character, press the button, twice,
rd
To input 3 character, press the button, three times,
(Ex., To input 'K', press the '5' button, twice).
3. To input a character in the same button, continuously
press the button after 2 seconds.
(Ex., in case of KL, press the '5' button twice, then
wait 2 seconds and press the '5' button three times).
Press /
HOLD SAVE
4.3.6 Using Automatic Called Number Redial (ACNR)
When making an external call and a busy signal is
received, the system can be set to retry the number until
the call is connected, the feature is cancelled, or the
maximum number of retries is attempted—this is
Automatic Called Number Redial (ACNR).
For each retry, the system will activate your speaker
then place the call with the microphone muted. When
the remote end answers, you must select the M
button, or lift the handset. Either of these actions will
cancel the ACNR request as well as connect you to the
remote party.
to place the call.
button,
PGM
.
42
User Guide
nd
Soft
UTE