Alarm/Door Bell; Power Fail Transfer; System Voice Memo - Ericsson iPECS LIP-8002E User Manual

LIP-8008E

7.5 Alarm/Door Bell

To terminate the Alarm signal:
•
Dial 565(iPECS-LIK & MG)/65(iPECS SBG-1000) (Alarm Stop
code).
To activate the Door Open contacts:
•
Lift the handset,
•
Dial #* (Door Open code) and contact number 1 to 4.
NOTE—Contacts 3 & 4 are only available in the iPECS -300 & 600.
Contacts 1 is available in the iPECS -MG.

7.6 Power Fail Transfer

7.7 System Voice Memo

The system can monitor external Alarm or Door Bell
contacts:
Alarm Monitor—should the external contact activate, a
unique Alarm Ring signal and LCD display may be
received. To restart the monitor circuit, the external
contacts must be deactivated and the Alarm Ring signal
terminated.
Door Bell—a unique Door Bell Ring (single tone burst)
may be received each time the external contact is
activated. A system contact also can be assigned to act
as a Door Open contact.
When AC power to the system fails, back-up operation
may be provided with back-up batteries or Power Fail
Transfer (PFT). When battery back-up is provided the
station will operate normally. When PFT is implemented,
an SLT is connected to a CO line by the system. This
SLT can be used as any normal SLT, providing service
while power is out.
The integrated Voice Mail modules incorporate several
Voice Memos to provide Station Users with general
information such as station number, date, time, and
feature status. Voice Memos can be heard over the
speaker or handset of the iPECS Phone and over the
handset for SLTs.
For the Station Status Memo, the following items are
reported:
42
User Guide