Differential Ring Signals; Differential Ring Signals - Ericsson iPECS LIP-8002E User Manual

LIP-8040E Gigabit Phone
To screen a call in Ring mode(iPECS-LIK & SBG)/LED blink
mode(iPECS-MG):
•
Press the flashing
over the station speaker and stored in the voice mailbox (in the
Speaker mode, broadcast is automatic).
To stop the voice broadcast and leave the caller in Voice Mail:
•
Press the illuminated
To talk with the caller and record the conversation in Voice Mail:
•
Press the
To answer the call and cancel the voice message recording:
•
Press the illuminated
the Voice Mail disconnected.
3.4

Differential Ring Signals

press the Flex button to hear the caller as the voice
message is stored.
Speaker mode (iPECS-LIK & SBG)/Speaker Hearing
Mode (iPECS-MG)—when the call is sent to the voice
mailbox, the caller's voice is automatically broadcast
over the speaker of your iPECS Phone.
You may terminate screening, leaving the caller in voice
mail to record a message, talk with the caller and record
the conversation in the mailbox, or answer the call and
disconnect the Voicemail.
available when using the iPECS VMIM/VSF Voice Mail;
a M and AME button should be programmed (refer
UTE
to Appendix A User Program Codes).
button, the caller's voice is broadcast
AME
SPEAKER
button.
MUTE
button, the caller is connected and
AME
When multiple phones in a small area ring, it can be
difficult to tell which are ringing. The iPECS Phone has
14 Ring Tones available for differentiating one phone's
ringing from another. Four of the tones are stored in the
phone permanent memory; the remaining ten tones are
in the system memory.
downloaded into the phone memory for use as the 5
th
8 Ring Tone.
22
The AME feature is only
button.
Four of these ten can be
User Guide
th
to