Alarm/Door Bell; Power Fail Transfer (Pft); System Voice Memo - Ericsson iPECS LIP-8002E User Manual

LIP-8012E & LIP-8024E Gigabit Phone
8.7

Alarm/Door Bell

To terminate the Alarm signal:
•
Dial 565(iPECS-LIK & MG)/65(iPECS SBG-1000) (Alarm Stop
code).
To activate the Door Open contacts:
•
Lift the handset,
•
Dial Door Open code, #* and contact number 1-4.
8.8

Power Fail Transfer (PFT)

8.9

System Voice Memo

The system can monitor external Alarm or Door Bell
contacts:
Alarm Monitor—should the external contact activate, a
unique Alarm Ring signal and LCD display may be
received. To restart the monitor circuit, the external
contacts must be deactivated and the Alarm Ring signal
terminated.
Door Bell—a unique Door Bell Ring (single tone burst)
may be received each time the external contact is
activated. A system contact also can be assigned to act
as a Door Open contact.
NOTE—Contacts 3 & 4 are only available in the
iPECS-300 & 600. Contacts 1 is available in the
iPECS -MG.
When AC power to the system fails, back-up operation
may be provided with back-up batteries or Power Fail
Transfer (PFT). When battery back-up is provided the
station will operate normally. When PFT is
implemented, an SLT is connected to a CO line by the
system. This SLT can be used as any normal SLT,
providing service while power is out.
The integrated Voice Mail modules incorporate several
Voice Memos to provide Station Users with general
information such as station number, date, time, and
feature status. Voice Memos are heard over the iPECS
Phone speaker and over the handset for SLTs.
For the Station Status Memo, the following items are
reported:
59
User Guide