Installing Additional Processors; Introduction; Tools Required; Processor Configuration Guidelines - HP NetServer LC 2000r Installation Manual

7 Installing Additional Processors

Introduction

The HP NetServer LC 2000/2000r supports two processors in primary and
secondary slots and both processors must operate at the same speed and cache
size.
The HP NetServer supports the Pentium III processors at a front side bus (FSB)
speed of 133 MHz. Advanced processors will be supported as each one becomes
available. Contact HP or your reseller for details.
The NetServer ships with one processor in the primary processor slot and one
voltage regulator module (VRM) installed its respective VRM slot. Both
processors and VRM slots are located on the system board.

Tools Required

An anti-static service kit (3M 8501/8502/8503 or equivalent). This kit
includes a static-dissipating work surface, a chassis clip lead, and a wrist
strap.

Processor Configuration Guidelines

The HP NetServer LC 2000/2000r supports a variety of processor speeds with an
FSB speed of 133 MHz.
CAUTION
Do not open the new processor's protective bag or remove it
from the bag until you are ready to install it.
Before you remove a processor from the anti-static container,
touch a grounded, unpainted metal surface on the HP
NetServer to discharge static electricity.
Both processor modules must be the same processor type and have the
same product number, which insures the same clock speed, cache size, and
FSB speed.
The processor modules must operate at the designated speed stated by the
product type on the processor.
71