HP NetServer LC 2000r Installation Manual page 11

Chapter 1
CAUTION The HP NetServer LC 2000 weighs approximately 80 lbs. (36
kg), which may be more than one person should lift. Do not
attempt to lift the HP NetServer by yourself. Failure to
observe this warning could result in serious injury, or damage
to the HP NetServer.
2. Familiarize yourself with the HP NetServer's controls, ports, and
indicators.
Refer to Chapter 2, "Controls, Ports, and Indicators."
3. If you have optional items to add to the HP NetServer (memory, accessory
boards, or processors), remove the front bezel and the left cover.
If there are no optional items to install, skip to step 8.
Refer to Chapter 3, "Opening and Closing the HP NetServer."
4. If you have items such as a processor, DIMMs, and accessory boards to
install, do so at this time.
All these items are installed on the system board without removing it and
can be installed at the same time.
Refer to Chapter 5, "Installing Additional Memory," Chapter 6, "Installing
Additional Boards," and Chapter 7, "Installing Additional Processors."
5. Install internal non-hot-swap mass storage devices such as hard drives and
tape back-ups into the front of the HP NetServer.
Refer to Chapter 4, "Installing Mass Storage Devices."
6. Reconnect all internal cables.
7. Replace all covers, including the bezel.
Refer to Chapter 3, "Opening and Closing the HP NetServer."
8. Install all Hot Swap disk drives into the front of the NetServer.
Refer to Chapter 4, "Installing Mass Storage Devices."
9. If a second power supply (optional) is needed, install it into the rear of the
HP NetServer.
Refer to the Power Supply accessory guide.
10. Hook up the monitor, keyboard, and mouse to the rear of the HP
NetServer.
Refer to Chapter 9, "Connecting Monitor, Keyboard, Mouse, and UPS."
Setting Up the HP NetServer
3