HP NetServer LC 2000r Installation Manual page 76

Chapter 6
9. Before installing the new PCI board:
Verify there is no handle attached to it, especially if it is a full-length
board.
If it has a handle attached, remove the handle before installing the
board into the slot.
NOTE
Use only the right side of the two slots in the board guide,
when installing PCI boards into some of the PCI slots
(P3 through P6) on the system board.
10. Align the board with its slot along its full length and position it into the
slot.
11. Push the PCI board down into its connector in the System board.
68
Installing Additional Boards