Tools Required - HP NetServer LC 2000r Installation Manual

Chapter 13
The HP NetServer LC 2000r rack mount kit requires five EIA units of space in the
rack. Before mounting the NetServer, plan for the NetServer's location in the rack
relative to other rack components. Proper placement is vital both for safety and
operating efficiency. For more details, see the Rack Installation Road Map and the
HP NetServer LC 2000r Rack Cabling Reference Guide.
NOTE
If the HP NetServer is completely configured by the vendor
before delivery to the customer, then mounting the HP
NetServer in the rack may be the final step in the installation
procedure. If the vendor configures the HP NetServer at the
customer's site, installation of the network operating system
and other software may occur after the HP NetServer is
mounted in the rack.
CAUTION
The HP NetServer weighs 80 lbs. (36 kg). To avoid accidents,
use two people when placing the HP NetServer into the rack.
If other rack components are to be mounted in the rack below
the HP NetServer, install those components before starting to
mount the NetServer.

Tools Required

You need these tools to mount the HP NetServer in the rack:
Nut driver or wrench
T-15 and T-25 Torx Drivers
Number 2 Phillips screwdriver
Marking pen
146
Alternative Rack Mounting