Dimm Removal - HP NetServer LC 2000r Installation Manual

Chapter 5
7. If the NetServer is in a rack installation, return the chassis into the rack.
Refer to Chapter 3, "Opening and Closing the HP NetServer."
8. Re-install the bezel onto the front of the HP NetServer.
Refer to Chapter 3, "Opening and Closing the HP NetServer."
9. Reconnect the power cord(s).
10. Power on the HP NetServer according to the respective NOS power-up
instructions.
Refer to Chapter 2, "Controls, Ports, and Indicators."
11. Return the HP NetServer to normal operation.

DIMM Removal

Use this procedure to remove DIMMs from the HP NetServer's system board. The
HP NetServer must be powered down and the appropriate cover must be removed
from the HP NetServer before removing any DIMMs.
1. If you have not already removed the appropriate cover from the HP
NetServer, perform one of the procedures listed below.
If the NetServer is mounted on the pedestal, perform Steps 1-8 in the
"Removing Covers – Pedestal (LC 2000)" in Chapter 3, "Opening and
Closing the HP NetServer," to gain access to the NetServer.
If the NetServer is in the rack, perform steps 1-14 in the "Removing
Covers – Rack Mount (LC 2000r)" in Chapter 3, "Opening and Closing
the HP NetServer," to gain access to the NetServer.
2. Select the desired DIMM(s) to remove.
3. Open the DIMM's retaining clips to lift the DIMM's top edge away from
the clips. See Figure 5-4.
4. Lift the DIMM completely away from the slot. See Figure 5-4.
5. Place the DIMM in its anti-static container.
Installing Additional Memory
59