HP NetServer LC 2000r Installation Manual page 124

Chapter 10
3. If necessary, use the arrow key to move to the Power-On Password menu
selection and press Enter.
The Power-On Password is highlighted by default when the Security menu
is selected.
The first line in the menu is, "Administrator Password is [Set or Not Set]"
If no password has been set, then "Not Set" will appear in the field. If
this is the case, then you are not allowed to make any other selections
in this menu, until you set an Administrator Password.
The Administrator Password controls access to the Setup Utility and its
settings. The User Password has only limited access to the Setup
Utility, such as Date, Time, and Password.
If "Set" is in the field, then you can change the password or make other
selections in the menu. However, you must start with the User
Password, but may choose to skip setting the User Password.
NOTE You must set the Administrator Password before changing a
User Password or configuring the HP NetServer to boot with a
password.
4. Press the Enter key to enter a new password or change the old one.
A pop-up menu appears titled, "Set Power-On Password". If no password
has been entered, the field "Enter New Password: [
a previous password has been entered, the field "Enter Old Password:
[ ]" is highlighted.
5. Enter the password (new or old) in the appropriate field and press Enter.
The password is accepted and the next field just below it, "Re-Enter New
Password: [
For security reasons, the password does not appear on the screen.
6. If necessary, enter the new password in the "Enter New Password: [
field.
7. Enter the new password again in the "Re-Enter New Password: [
field.
After re-entering the new password a pop-up menu displays asking you to
confirm your selection.
116
]" or "Enter New Password: [
Configuring the HP NetServer
]" is highlighted. If
]" field is highlighted.
]"
]"