B Regulatory Information; Regulatory Notices - Electromagnetic Compliance; Notice For United States - HP NetServer LC 2000r Installation Manual

B Regulatory Information

Regulatory Notices - Electromagnetic Compliance

Electromagnetic Compatibility (EMC) requirements have been established in
many countries to regulate the radio frequency energy generated by Information
Technology Equipment (ITE). This energy is generated during the normal and
intended use of this equipment and so it is limited by country regulations to levels
intended to minimize potential interference to other electrical equipment,
including public safety services.
Two levels of radio frequency energy are allowed according to the type or use of
equipment. Class A levels have been established for use in commercial or
business environments. Class B levels are lower than the class A requirement and
have been established for use in residential environments. Class B levels are also
suitable when the environment includes electrically sensitive equipment.
The NetServer equipment you have purchased has been provided with a
compliance label to indicate where it may be used with reasonable protection to
the environment in which it is used. Additional statements are provided below as
required by the requirements of international and domestic regulations.
NOTE Check the label on your product to determine the level of
operation.

Notice for United States

Class B Equipment
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC (Federal Communications
Commission) Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates
and uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to correct the interference by one or more of the
following measures:
167