HP NetServer LC 2000r Installation Manual page 74

Chapter 6
5. Gain access to the NetServer by performing the appropriate procedure for
the NetServer LC 2000 or the LC 2000r.
If the NetServer is mounted on the pedestal, perform Steps 1-8 in the
"Removing Covers – Pedestal (LC 2000)" in Chapter 3, "Opening and
Closing the HP NetServer," to gain access to the NetServer.
If the NetServer is in the rack, perform steps 1-14 in the "Removing
Covers – Rack Mount (LC 2000r)" in Chapter 3, "Opening and Closing
the HP NetServer," to gain access to the NetServer.
6. Consider the boot priority before installing any accessory boards.
See Figure 6-1.
If installing a SCSI disk controller board, the controller's priority (BIOS
search order for a boot drive) is set by the board's slot location. For details,
refer to Boot Priority earlier in this chapter.
7. Identify the desired slot (P1 through P6), before installing the accessory
board. See Figure 6-1.
66
Installing Additional Boards