HP NetServer LC 2000r Installation Manual page 12

Chapter 1
11. Connect all other external cables to the rear of the HP NetServer.
12. Obtain the release history of the HP NetServer Navigator CD-ROM
provided with the HP NetServer to ensure you have the latest Navigator
CD-ROM.
Refer to Chapter 10, "Configuring the HP NetServer."
13. Power up the HP NetServer.
Refer to Chapter 2, "Controls, Ports, and Indicators."
14. Insert the Navigator CD-ROM and reboot the HP NetServer.
15. Check the Navigator README file for important installation information.
Refer to Chapter 10, "Configuring the HP NetServer."
16. Configure the HP NetServer with Configuration Assistant from the
Navigator CD-ROM, using the Express Configuration option.
Refer to Chapter 10, "Configuring the HP NetServer."
NOTE To fully configure the HP NetServer, all external components
should be cabled and online.
17. Verify the HP NetServer's operation and troubleshoot if necessary.
Your HP NetServer installation should be complete. If not, refer to
Chapter 12, "Troubleshooting."
18. If you plan to ship the fully-configured HP NetServer LC 2000 to a
different destination:
a. Label each cable and component to facilitate re-assembly.
b. Repack the components in the original packing material, and prepare
each one for shipment.
CAUTION It is critical to disassemble and rebox all electronic
components before reshipment. Electronic components
(especially hard disk drives) can sustain damage when shipped
in rack enclosures.
4
Setting Up the HP NetServer