Processor Load Order; Required Tools; Installing A Dual-Core Processor - HP Integrity rx3600 Installation Manual

The server can contain one or two dual-core processors that provide the following configuration
options:
1P/2C (One processor/two cores)
2P/4C (Two processors/four cores)
WARNING!
from the server prior to performing this procedure.
Voltages are present at various locations within the server whenever an AC power source is
connected. This voltage is present even when the main power switch is in the off position.
Failure to observe this warning can result in personal injury or damage to equipment.
CAUTION:
to observe this caution results in performance degradation or system failure.
To ensure compatibility, use dual-core processors with identical part numbers.
CAUTION:
ESD safety precautions can result in damage to the server.

Processor Load Order

The server can have up to two dual-core processors on the processor board. The slots on the
processor board are labeled Module 0 and Module 1.
Table 8 lists the processor load sequence.
Table 8 Processor Load Order
Dual-Core Processor

Required Tools

To install processors, use the processor install tool fastened to the processor board.

Installing a Dual-Core Processor

To install a dual-core processor, follow these steps:
1. Remove the memory carrier assembly cover. See
Cover" (page
NOTE:
the top cover release lever must be open.
2. Remove the memory carrier assembly. See
NOTE:
board.
3. Remove the processor board assembly. See
(page 28).
30 Installing the System
Ensure that the system is powered off and all power sources have been disconnected
Ensure that processor speed and cache size are identical for all processors. Failure
Observe all ESD safety precautions before attempting this procedure. Failure to follow
1
2
13).
You do not need to fully remove the top cover to service this component; however,
You must remove the memory carrier because it attaches directly to the processor
Slot
"Removing the Memory Carrier Assembly
"Removing the Memory Carrier Assembly" (page 21)
"Removing the Processor Board Assembly"
Module 0
Module 1