Firmware; Figure 42 Advanced > System Configuration > Firmware - ZyXEL Communications MAX-206M1R series User Manual

Chapter 9 The System Configuration Screens
Table 32 ADVANCED > System Configuration > Dynamic DNS (continued)
LABEL
Enable offline
option
IP Address Update Policy
Use WAN IP
Address
Dynamic DNS
server auto
detect IP
address
Use specified IP
address
Apply
Reset

9.4 Firmware

Click ADVANCED > System Configuration > Firmware to upload new
firmware to the WiMAX Modem. Firmware files usually use the system model
name with a "*.bin" extension, such as "WiMAX Modem.bin". The upload process
uses HTTP (Hypertext Transfer Protocol) and may take up to two minutes. After a
successful upload, the system will reboot.
Contact your service provider for information on available firmware upgrades.
Note: Only use firmware for your WiMAX Modem's specific model.
Figure 42 ADVANCED > System Configuration > Firmware
104
DESCRIPTION
This field is available when CustomDNS is selected in the DDNS Type
field. Select this if your Dynamic DNS service provider redirects traffic
to a URL that you can specify while you are off line. Check with your
Dynamic DNS service provider.
Select this if you want the WiMAX Modem to update the domain name
with the WAN port's IP address.
Select this if you want the DDNS server to update the IP address of the
host name(s) automatically. Select this option when there are one or
more NAT routers between the WiMAX Modem and the DDNS server.
Note: The DDNS server may not be able to detect the proper IP
address if there is an HTTP proxy server between the
WiMAX Modem and the DDNS server.
Select this if you want to use the specified IP address with the host
name(s). Then, specify the IP address. Use this option if you have a
static IP address.
Click to save your changes.
Click to restore your previously saved settings.
User's Guide