Class Setup; Figure 86 Qos > Class Setup; Table 73 Qos Class Setup - ZyXEL Communications MAX-206M1R series User Manual

Chapter 17 QoS

17.3 Class Setup

Use this screen to add, edit or delete QoS classifiers. A classifier groups traffic into
data flows according to specific criteria such as the source address, destination
address, source port number, destination port number or incoming interface. For
example, you can configure a classifier to select traffic from the same protocol
port (such as Telnet) to form a flow.
You can give different priorities to traffic that the WiMAX Modem forwards out
through the WAN interface. Give high priority to voice and video to make them run
more smoothly. Similarly, give low priority to many large file downloads so that
they do not reduce the quality of other applications.
Click TOOLS > QoS > Class Setup to open the following screen.
Figure 86 QoS > Class Setup
The following table describes the labels in this screen.

Table 73 QoS Class Setup

LABEL
Create New Class Click this button to create a new class.
#
Active
Name
Interface
DSCP
Class Index
Action
Apply
Cancel
196
DESCRIPTION
This field displays the index number of the class.
This field indicates whether the QoS class is enabled or not.
This field indicates the name of the class.
This field indicates the Ethernet port on which traffic is being
monitored and prioritized.
This field indicates the Differentiated Services Code Point (DSCP)
value for the associated class.
This field indicates the index for this QoS class. Classes are
implemented based on index number, from lowest to highest.
Click the Edit icon to go to the screen where you can edit the rule.
Click the Delete icon to delete an existing rule. Note that subsequent
rules move up by one when you take this action.
Click this button to save your changes back to the WiMAX Modem.
Click this button to begin configuring this screen afresh.
User's Guide