Table 24 Advanced > Wan Configuration > Advanced - ZyXEL Communications MAX-206M1R series User Manual

Chapter 7 The WAN Configuration Screens
The following table describes the labels in this screen.
Table 24 ADVANCED > WAN Configuration > Advanced
LABEL
DNS Servers
First, Second and
Third DNS Server
RIP & Multicast Setup
RIP Direction
RIP Version
Multicast
Windows Networking (NetBIOS over TCP/IP)
Allow between LAN
and WAN
Allow Trigger Dial
Apply
Reset
88
DESCRIPTION
Select Obtained from ISP if your ISP dynamically assigns DNS
server information (and the WiMAX Modem's WAN IP address). Use
the drop-down list box to select a DNS server IP address that the
ISP assigns in the field to the right.
Select UserDefined if you have the IP address of a DNS server.
Enter the DNS server's IP address in the field to the right. If you
chose UserDefined, but leave the IP address set to 0.0.0.0,
UserDefined changes to None after you click Apply. If you set a
second choice to UserDefined, and enter the same IP address, the
second UserDefined changes to None after you click Apply.
Select None if you do not want to configure DNS servers. You must
have another DHCP server on your LAN, or else the computers
must have their DNS server addresses manually configured. If you
do not configure a DNS server, you must know the IP address of a
computer in order to access it.
Select the RIP direction from None, Both, In Only and Out Only.
Select the RIP version from RIP-1, RIP-2B and RIP-2M.
IGMP (Internet Group Multicast Protocol) is a network-layer
protocol used to establish membership in a multicast group. The
WiMAX Modem supports both IGMP version 1 (IGMP-v1) and
IGMP-v2. Select None to disable it.
Select this check box to forward NetBIOS packets from the LAN to
the WAN and from the WAN to the LAN. If your firewall is enabled
with the default policy set to block WAN to LAN traffic, you also
need to enable the default WAN to LAN firewall rule that forwards
NetBIOS traffic.
Clear this check box to block all NetBIOS packets going from the
LAN to the WAN and from the WAN to the LAN.
Select this option to allow NetBIOS packets to initiate calls.
Click to save your changes.
Click to restore your previously saved settings.
User's Guide