Reset To Default Screen; Firmware Upgrade Screen - ZyXEL Communications WAH3004 User Manual

Figure 41 System > Configuration > Restore
Do not turn off the WAH3004 while configuration file upload is in
progress.
After the WAH3004 configuration has been restored successfully, the login screen appears. If you
uploaded the default configuration file you may need to change the IP address of your computer to
be in the same subnet as that of the default device IP address (192.168.0.254).

9.3.3 Reset to Default Screen

To access this screen, click System > Configuration > Reset to Default. Click the Reset button
to clear all user-entered configuration information and return the WAH3004 to its factory defaults.
The WAH3004 automatically restarts.
Figure 42 System > Configuration > Reset to Default
You can also press the Reset button on the rear panel to reset the factory defaults of your
WAH3004. Refer to

9.4 Firmware Upgrade Screen

This screen allows you to upload new firmware to your WAH3004. You can download new firmware
releases from your nearest ZyXEL FTP site (or www.zyxel.com) to use to upgrade your device's
performance.
Only use firmware for your device's specific model.
To access this screen, click System > Firmware Upgrade. Type in the location of the file you want
to upload in the File name field or click Browse ... or Choose File to find it. Remember that you
Chapter 9 System
Section 1.6 on page 11
WAH3004 User's Guide
64
for more information on the Reset button.