System Programming - Bosch solution 6000 Installation Manual


T
his section contains the different parameters required
that are system related features.
The commands menu will allow you to view the panel
status, system troubles, history log, factory default and
entering service mode.
Some of the key parameters in these menus are the setting
of the date/time under Clock and Schedules which control
all the automated time functions of the system.
S YS T E M CO M M A N D S
System > Commands >
Panel Status
This command displays the following panel related
information on the keypad display.
Line 1 Displays:
The panel number that you are getting information from
(eg. Node 1 = Panel 1 etc). The Solution 6000 is only
configured to work with one panel.
Line 2 Displays:
The panel name and firmware version number.
Line 3 Displays:
The current panel temperature, panel power supply
voltage and any system troubles which are in effect. This
line scrolls all events continiously
1) Press [MENU] + [7] + [0] + [0] to view the panel
status.
Panel 1
Solution 6000 Ver 2.00.00
Temperature = 33
Press OK or MENU
2) Press [OK] to exit when finished.
Bosch Security Systems 07/14 BLCC610I

System Programming

- -
   MENU 7-0-0
System > Commands >
System Trouble
This command lists any system troubles which are
currently in effect on the system. Information is diplayed
in a list format allowing you to select a paticular event and
then drill down to view more specific information.
System trouble events such as Failure To Comminicate or
Telco Line Fail are grouped under System Trouble in the
list while open zones are displayed individually one per
line.
When the keypad is in standby mode, system troubles
and open zones will be displayed on the status line of the
keypad. From this mode you can access the list of troubles
by pressing the down arrow.
1) Press [MENU] + [7] + [0] + [1] and use the up and
down arrows to highlight the trouble event in the
list then press [OK].
System Trbl
Zn1 Zone 1 Name
Zn2 Zone 2 Name
Press  OK or MENU
2) Selecting System Trouble from the list will show the
specific panel version information to be displayed
in the first two lines while the third line of the
display will scroll all current system trouble events.
Panel 1
Solution 6000 Ver 2.00.00
Date and Time
Press OK or MENU
3) Selecting a Zone from the list will show the currrent
zone state.
Zone 1 Zame Zn1
EOL=Open 53020 ohms
Press OK or MENU
4) If no System Troubles are in effect the keypad will
display.
S E C TI O N 11
- -
   MENU 7-0-1
11-1