Table of Contents
Advertisement
11.6.9 Port Setup Screen
Select Port 1 or Port 2 from the Setup menu to display one of the Port Setup
screens. The Port Setup screens allow you to specify settings for the two serial
communication ports on the UPS. Figure 11---11 shows the Setup Serial Port 1
screen.
UPS System Normal
Alarm:
Notice: None
Battery
Minutes
48.5
Setup
Port 1
Port 2
Time
Language
Meters
The small return arrow (
screen. This arrow is a reminder that you can press the
Monitor Panel to toggle the pushbuttons between the menu box and the
information area. When the scroll bar is in the information area, the return arrow is
in the menu box. When the scroll bar is in the menu box, the return arrow is in the
information area.
When the scroll bar appears in the information area, you can use the pushbuttons
to change the port configuration. To change a setting, press the
to move the highlight to the setting you want to change. To scroll through the
available options for that setting, press the
settings upon exit from this screen, be sure the SAVE field is set to YES.
The setup screens for Port 1 and Port 2 are identical. For detailed information
about configuring the serial ports, refer to Chapter 15, "Serial Communications."
11--14
Uninterruptible Power System
None
MODE
TERMINAL
Events
Statistics Graphics
Figure 11 ---11. Port Setup Screen
) appears in the upper right corner of the Port Setup
4 MAY 1999
Setup Serial Port 1
RATE
DATA/STOP
HANDSHAKING
9600
8
1
XON / XOFF
Setup
or
pushbutton. To save the
Powerware 9315 (500 kVA- -750 kVA) Installation and Operation
09:25:42
SAVE
NO
pushbutton on the
and
pushbuttons
164201244 REV. D 030101
Advertisement
Table of Contents
