Table of Contents
Advertisement
Operational Controls
and Features
10.1 General
The UPS system should function automatically and require very little attention
during normal operation. The controls and indicators identified in this section are
used during startup, to monitor normal operation and during abnormal events.
Figure 10---1 identifies and shows the location of the controls and indicators on the
UPS. The descriptions provide a brief overview of the UPS controls, and standard
and optional features.
NOTE: Read the Operation section of this manual and have thorough knowledge
of UPS operation before attempting to operate any of the UPS controls or
optional components.
10.2 UPS Standard Features
The UPS has many standard features that provide cost-effective and consistently
reliable power protection:
10.2.1
Control Panel
The Control Panel on the front of the UPS contains an LCD screen to display the
current status of the UPS system. You can view a statistical history and log of
system events and display a real-time graphic representation of power flowing
through the system components. Backlit status indicators show the operating
mode of the UPS and alert you to system events. The BATTERY switch controls
the application of battery power to the UPS. The MODE switch, also located on this
panel, is used to start and stop the system and transfer the load between normal UPS
operation and bypass operation. The EMERGENCY UPM OFF pushbutton is
located at the top of the control panel, and the PUSH IN TO RESET button for the
EMERGENCY UPM OFF is located between the BATTERY and MODE switches.
The Control Panel is described in Chapter 11, "Using the Control Panel".
Powerware 9315 (500 kVA- -750 kVA) Installation and Operation
164201244 REV. D 030101
10
10--1
Advertisement
Table of Contents
