Final Modem Configuration - Powerware Uninterruptible Power Supply Installation And Operation Manual

7. Key in [A], [T], [&], [W], [0] (zero), then press [ENTER].
6. Confirm that the modem responds with "OK" or "0" (zero).
7. Key in [A], [T], [&], [W], [0] (zero), then press [ENTER].
8. Confirm that the modem responds with "OK" or "0" (zero).
9. Connect a telephone line to the modem and test the modem by keying in [A], [T],
[D], [S], [0] (zero), then pressing [ENTER].
10. The modem dials the telephone number stored in step 4 or step 5. (The number is
displayed on the terminal screen as it is dialed.) Confirm that the pager receives
the message. Repeat steps 4 (or 5) through 9 as required to modify the telephone
number and message.
NOTE: To set up a group one or group two number to call a computer, refer to
"Configuring the Modem to Call a Remote Computer" section of this chapter.
To configure the modem to answer incoming calls, perform the following
procedure.

16.5.4 Final Modem Configuration

The final step in configuring the PC modem for use with the UPS is to turn off the
echo feature of the modem. Perform the following procedure.
16--8
Powerware 9315 (500 kVA- -750 kVA) Installation and Operation
164201244 REV. D 030101