Display Mask - Toshiba Satellite P10 Series Maintenance Manual

4.18 Display Mask

4.18 Display Mask
Removing the Display Mask
To remove the display mask, first remove the battery pack and the display assembly as described
earlier, then follow the steps below.
1. Remove four mask seals to expose two upper outer corners screws and two lower
inner corner screws securing the display mask.
2. Remove one M2×6 black screw from each corner that were covered by the mask seals.
3. Carefully insert your fingers between the mask and the LCD panel and pry open the
snaps. Start with the four snaps at the top of the display mask. Continue unsnapping
the display mask along the two sides and the bottom edge.
Satellite P10 Series Maintenance Manual
Figure 4-26 Removing the display mask screws
4 Replacement Procedures
4-49