Toshiba Satellite P10 Series Maintenance Manual page 165

4 Replacement Procedures
NOTE: If the LCD module malfunctions, remove the LCD cable and LCD bracket. Then
replace the whole LCD module unit.
Installing the LCD Module
To install the LCD module, follow the steps below and refer to the figures in the preceding
section.
1. Set the LCD module in the display assembly.
2. Connect the FL cable and the HV cable to the FL inverter board.
3. Secure the LCD module in the display assembly with the LCD module bracket and
eight M2.5x3 black screws.
4. Secure one M2x3 black screw holding the left HV cable in place.
4-52
4.19 LCD Module
Satellite P10 Series Maintenance Manual