Toshiba Satellite P10 Series Maintenance Manual page 139

4 Replacement Procedures
2. Remove four embedded screws securing the fan module. Next, disconnect the fan
module's black and white power cables from the system board.
3. Remove the four embedded screws securing the heat sink. These should be removed in
numerical order so as not to place undo stress on the CPU below. The numbers are
embossed on the heat sink chassis.
4. Lift off the heat sink.
CAUTION: If you remove the heat sink, you should use the CPU grease tool to remove
the grease on the CPU and heat sink. Reapply fresh grease before replacing the heat sink.
4-26
Figure 4-13 Removing the heat sink
4.9 Fan, Heat Sink, & CPU
Satellite P10 Series Maintenance Manual