4 Replacement Procedures
Installing the TouchPad
To install the TouchPad, follow the steps below and refer to the figure in the preceding section.
1. With the top cover upside down, place the TouchPad, the TouchPad cover, and PPC
Board in position.
2. Secure the PPC Board with two M2.5x2 black screws.
3. Secure the TouchPad cover over the TouchPad with three M2.5×3 black screws.
4. Connect the upper and lower TouchPad board FPC cables to both the TouchPad
button board and the TouchPad.
5. Restore the battery pack, keyboard, optical drive module, HDD, and top cover as they
were originally.
4-42
4.14 TouchPad
Satellite P10 Series Maintenance Manual